A Brandt company - serving Enterprise, NV

Lennox Heat Pump Service in Enterprise, NV

Heat pumpsHeat pumps
AC repairAC repair
Furnace & heatingFurnace & heating
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

We have financing partners for your new heating and cooling system*On approved credit; ask us about your options

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Lennox Heat Pump Service: The Enterprise Owner’s Guide

Lennox heat pump service in Enterprise usually runs $150 – $650 for the repair itself, with most single-component fixes landing in the lower half of that range once we’ve matched the exact part to your model. Every job starts with a written price before we touch anything, and for a failed part we can often get a technician to you the same day. Owners in Enterprise typically find us after a heat pump has quit heating during a cold snap, tripped a breaker mid-cycle, or started short-cycling every few minutes with the thermostat still calling for heat.

Call (844) 797-9490

Heat pumps in Enterprise work harder than in most of Nevada. Summer highs around 100°F push the compressor and reversing valve into constant duty, and winter lows in the high 20s and low 30s mean the defrost cycle is cycling almost every hour. That back-and-forth is what wears out the parts this page covers. We connect you with independent local technicians who work on Lennox systems directly, so you’re not bounced between a manufacturer hotline and a contractor who only wants to sell you a new unit.

  • The part is matched to your Lennox model number, not guessed from a photo.
  • You see a written price before any work starts.
  • Every repair carries a written guarantee, and the 365-Day Done Right Promise means a failed repair gets a free return visit.
  • Calls are answered by a live person, day or night.

Which Lennox Models This Applies To

Lennox heat pumps come through Enterprise homes across several lines: the Merit series (14HPX and similar), the Elite series, and the Dave Lennox Signature Collection units. The part that fails most is usually specific to the refrigerant generation. Models built for R-410A and older R-22 systems use different reversing valve connections, different defrost control boards, and different sensors, and the two are not interchangeable even when the cabinets look identical. That’s the single most common compatibility gotcha we run into: a homeowner buys a board on their own, then finds the harness plugs don’t match because the replacement was spec’d for a different generation.

To identify the right part, get the full model number from the data plate on the outdoor unit, not the sales brochure name. It’s usually on a sticker near the electrical access panel, and it reads something like 14HPX-036-230. The middle number is capacity in thousands of BTUs, which matters for compressor and fan motor sizing. The voltage suffix tells you single-phase or three-phase. A photo of the data plate and the failed part is enough for a technician to confirm fit before showing up.

On the OEM-versus-aftermarket question: Lennox-branded OEM parts are the safest match for sensors and control boards because the firmware is set for that cabinet. For contactors, capacitors, and fan motors, a quality aftermarket equivalent from a known manufacturer is often the same component in a different box. We don’t carry stock and don’t claim to. We source the part for your model and tell you at the price quote which route we’re taking and why.

We’re an independent service provider. Brandt HVAC Enterprise is not affiliated with Lennox, and we also service Carrier and Trane systems alongside Lennox.

Explore

Styles & brands we work with

  • AC repair
  • Furnace & heating
  • Heat pumps
  • Ductless mini splits
  • Carrier
  • Trane
  • Goodman

Signs Your Lennox Heat Pump Service Is Failing

The failure shows up long before the system stops. Here’s what Enterprise owners report, and what’s usually underneath it:

  • Heat pump runs but blows cool air in heating mode. Most often a reversing valve that’s stuck or a failed solenoid coil. The valve is what switches the refrigerant flow between heating and cooling; when it fails, the system keeps running but pushes the wrong direction.
  • System short-cycles every 3 – 10 minutes. A failing defrost control board or a bad high-pressure switch is the usual cause. In Enterprise’s cold-morning defrost cycles, a board that misreads the coil sensor will trigger defrost too often, and the compressor never gets a full run.
  • Outdoor fan won’t spin, or spins only sometimes. A failing fan motor or a bad run capacitor. When the capacitor weakens, the motor struggles to start, and on a 100°F day it can overheat and shut down on thermal protection within minutes.
  • Breaker trips when the heat pump starts. A shorted compressor winding, a failing contactor, or loose high-voltage connections. This is an electrical fault, not a tune-up issue, and should be looked at before the breaker is reset again.
  • Ice on the outdoor coil that doesn’t clear. A defrost sensor or board problem, or low refrigerant charge from a slow leak. Persistent ice in Enterprise’s mild winters is a real signal, not normal operation.

Replacement Cost & What’s Included

Heat pump part replacement in Enterprise typically runs $150 – $650 installed, parts and labor together. The low end is a capacitor or contactor swap. The middle is a fan motor, defrost board, or reversing valve solenoid. The upper end covers a compressor start component or a more involved control board replacement on a Signature series unit, where the board itself is pricier and the diagnostic time is longer.

Repair Installed Price Range
Capacitor or contactor $150 – $260
Defrost control board $280 – $450
Reversing valve solenoid $250 – $420
Outdoor fan motor $350 – $550
Compressor start components / control board $450 – $650

What drives the range: the part itself, model-specific availability, and how much diagnostic time the fault takes to isolate. The written price we give you before work starts covers all three. Every repair includes a written guarantee, and the 365-Day Done Right Promise means if the same repair fails, we return at no charge. Free estimates are standard; nothing is ordered or installed until you agree to the number in writing.

Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

DIY or Call Us?

Some things a careful homeowner can check safely. Others we’d rather you didn’t touch. The safe side: confirm the breaker isn’t tripped, check that the thermostat is set to Heat and calling for it, look at the outdoor unit for obvious ice or debris blocking airflow, and write down the data plate model number. That’s useful information for us and costs nothing.

The unsafe side is anything inside the electrical panel or the outdoor unit cabinet. A heat pump capacitor holds a lethal charge even after the disconnect is pulled, and the compressor circuit runs 240 volts. Reversing valve work involves refrigerant under pressure; releasing it is both dangerous and illegal without certification. We’d rather you call than open the panel. A technician can diagnose the fault, quote the part in writing, and have your heat pump running the same day in most cases.

If you want a second set of eyes on a diagnosis you’ve already received, that’s a fine reason to call too. We’ll give you an honest read and a written price before anything is ordered.

FAQs

Talk to Brandt HVAC Enterprise About Your Lennox Heat Pump

If your Lennox heat pump has quit, is short-cycling, or is showing any of the symptoms above, call (844) 797-9490 for a free estimate. We’ll match the part to your model, give you a written price before any work starts, and get a background-checked, identity-verified technician to your door. A live person answers the phone, day or night. One of our technicians can be at your home in Enterprise the same day in most cases.

Written by the team at Brandt HVAC Enterprise, serving Enterprise and nearby areas.

Need HVAC help nationwide? Licensed & insured · 30-60 min response · free estimates
Call (844) 797-9490
Local Service Coverage

Request a Free Estimate in Enterprise

Tell us what you need - Brandt HVAC Enterprise responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch