A Brandt company - serving Enterprise, NV

Rheem Heat Pump Service in Enterprise, NV

Heat pumpsHeat pumps
AC repairAC repair
Furnace & heatingFurnace & heating
Ductless mini splitsDuctless mini splits
CarrierCarrier
TraneTrane
GoodmanGoodman
Every visit starts with

Seasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed

We have financing partners for your new heating and cooling system*On approved credit; ask us about your options

Diagnosis first, numbers second - you approve the repair price before a single part goes in.

Get your free estimate

Rheem Heat Pump Service: The Enterprise Owner’s Guide

We provide Rheem heat pump service in Enterprise, including the part repairs and replacements that get a system back to heating and cooling. Most heat pump part repairs run $150 – $650 in parts and labor, and we offer same-day service on many failures. You usually find out something is wrong the same way every Enterprise homeowner does: the house won’t hold temperature during a cold snap or a 108°F July afternoon, the outdoor unit hums without the fan spinning, or the system trips the breaker every time it starts. In Enterprise, that pattern often points to a failed capacitor, contactor, reversing valve coil, or defrost control board, and each one gets a different fix.

Call (844) 797-9490

Which Rheem Models This Applies To

The parts we replace most often fit Rheem’s mainstream residential heat pump lines: the Classic and Prestige series, the RP14, RP15, RP17, and RP20 families, and the older RQ and RPQL outdoor units that are still common on Enterprise homes. Rheem uses model-specific part numbers, and this is where compatibility gets owners in trouble. A run capacitor from one Rheem model group is often not interchangeable with another, even though the physical can looks the same. The microfarad (µF) rating and voltage must match the nameplate exactly. A 35/5 µF 370V capacitor is a different part from a 35/5 µF 440V unit, and the wrong substitute can shorten the compressor’s life.

To identify your part, check the data plate on the outdoor unit for the model and serial number, then look at the capacitor or board itself. The ratings are printed on the side of the part. We’ll match OEM Rheem parts when they’re available and a quality aftermarket equivalent when they aren’t, and we’ll tell you which one we’re using and why. We’re an independent service provider, not affiliated with Rheem, and we source by your model number, not by guesswork.

Explore

Styles & brands we work with

  • AC repair
  • Furnace & heating
  • Heat pumps
  • Ductless mini splits
  • Carrier
  • Trane
  • Goodman

Signs Your Rheem Heat Pump Service Is Failing

  • The outdoor fan hums but doesn’t spin. A weak or bulging run capacitor is the usual cause; the motor has power but no starting torque.
  • The system trips the breaker on startup. A shorted compressor, a stuck contactor, or a failed capacitor can all draw too much current at once.
  • It heats in summer or cools in winter. A failed reversing valve coil or a stuck valve leaves the system in the wrong mode, and the coil is usually cheaper to replace than the valve itself.
  • The unit ices over in heating mode. A defrost control board or sensor that won’t cycle correctly lets frost build on the outdoor coil; in Enterprise’s dry winter air, we see this sooner than you’d expect.
  • Short cycling or a dead thermostat. A failing contactor or low-voltage transformer can shut the system down before it finishes a cycle; we test both with a meter.
Before & after

See the difference

Before - Recent ProjectBeforeAfter - Recent ProjectAfter
Recent Project
Before - Full RestorationBeforeAfter - Full RestorationAfter
Full Restoration
Before - Complete UpgradeBeforeAfter - Complete UpgradeAfter
Complete Upgrade

Replacement Cost & What’s Included

Most Rheem heat pump part repairs in Enterprise land within our $150 – $650 AC repair range, parts and labor together. The lower end is a capacitor or contactor swap; the upper end is a reversing valve coil, defrost board, or control board with the diagnostic and reconnection time it takes. What moves the number is the part itself, whether the system needs evacuation and recharge of refrigerant to reach the component, and how accessible your outdoor unit is. We give you a written price before any work starts, so you know the full cost before a tool comes out of the bag. Every repair carries a written guarantee, and if it fails within the guarantee period, we come back free under our 365-Day Done Right Promise.

DIY or Call Us?

You can safely check a few things yourself: confirm the breaker isn’t tripped, look at the thermostat batteries, and eyeball the outdoor unit for ice or debris against the coil. But the parts on this page are capacitor, contactor, board, and valve work, and the capacitor and compressor terminals hold a charge that can hurt you even with the power off. Capacitors can hold voltage after the disconnect is pulled, which is where DIY heat pump repair goes wrong. That’s a job for a trained technician who knows how to discharge and test safely. Our technicians have up to 23 years of experience, and we’ll tell you exactly what failed and what it costs. Call (844) 797-9490 for a free estimate.

FAQs

Need HVAC help nationwide? Licensed & insured · 30-60 min response · free estimates
Call (844) 797-9490
Local Service Coverage

Request a Free Estimate in Enterprise

Tell us what you need - Brandt HVAC Enterprise responds fast. No obligation.

By submitting this form you agree to our Privacy Policy and consent to be contacted by phone, email or SMS about your request, including by local professionals who may handle it.

Call Now - 24/7 Dispatch